Description

DESCRIPTION

Product parameters
Working voltage: 4.8～8.4V Current consumption: 20mA/6V Working temperature: -10℃+50℃
Support input signal: PWM (50-333Hz)/FUTABA S.BUS
output servo signal: 1520uS (333Hz) control System: PID control system

Switch function setting: SW setting switch (servo stroke setting, forward and reverse setting):

Trip setting:
pressing the SW power switch, while the lights flash slowly into the servo travel is provided, the remote control’s rudder, the steering gear to a desired position on the go (to the left / right), short press
click SW switch, 2 the flash lights, red light becomes steady, slow flashing green light, indicating that the trip has been saved, then the remote control’s rudder, the steering gear to the other direction to
position to the desired, short press a lower switch, traffic lights Fast flash 2 times , and then the red and green lights are on, indicating that the itinerary has also been saved. The gyroscope will automatically enter the initialization after 2S, and
it can work normally after the initialization is completed.

Stroke restore the default settings:
pressing the SW power switch into the travel mode set, after press switch 3S, lights start to alternate, 2S reset to the default settings. Then enter initialized, which finished
after to work properly.

Sensitivity forward and reverse setting: In
normal working state, after long pressing the SW switch for 3 seconds, the green light flashes 3 times slowly to switch the sensitivity forward and reverse.

Signal input mode:

1.PWM (50-333Hz) for most remote control system, when the line is not inserted sensitivity, the gyroscope itself electric positioner do sensitivity control mode.

2. FUTABA S.BUS is suitable for FUTABA S.BUS remote control system. When using S.BUS signal input, the default CH3 channel is used for gain mode control, and the gyroscope gain line is
not used.

Sensitivity mode function:

1. Use the remote control sensitivity channel to adjust the sensitivity (default for SBUS input), the range is from -100% to 0 to +100%.

When working with the sensitivity channel, the green light is always on.

a. 0 means no sensitivity. b. -100% / +100% is the maximum sensitivity

2. When the sensitivity line input is not used, use the potentiometer of the gyroscope to adjust the sensitivity. Red light is always on

Fonctions:
LED status
Green flashing gyroscope initialization
Green slow flashing remote control signal lost
Green steady working mode/sensitivity channel adjustment sensitivity
Constant red working mode / gyroscope potentiometer to adjust the sensitivity
Red slow flashing sensitivity forward and reverse settings
Yellow slow flashing stroke setting mode

Available in 3 colors:
Red: GYRO-V3-RD
Black: GYRO-V3-BK
Purple: GYRO-V3-VT